Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.2 INITIAL OPERATION (FIRST SWITCH-ON)
When the unit is secured to a wall and correctly connected to the mains supply, press the ON/OFF
button located on the right side.
SWITCH-ON
When your heater is switched on, the programmer reads the internal memory in order to load the
last mode selected by the user.
If it is the rst switch-on, the memory is empty and the screen will constantly ash until the
key is pressed.
During operation, the thermostat displays the user-selected temperature and/or the current
operating mode:
COMFORT
The
symbol is visible while the heater is switched on.
1.3 PROGRAMMING THE CURRENT DAY AND TIME
1) Check that the thermostat is in the Standby position (time displayed) or
time ondisplay.
If it is not in Standby, press the
2) Press the
3) Press the
4) Select the day of the week by using the
to con rm.
5) Select the time by pressing the
6) Select the minutes by using the
7) Con rmation produces a return to the Standby position.
Important notes:
When the heater is switched o or mains power is not available for a time exceeding approximately four hours, the
memory will retain the programmed parameters (temperatures and programming), except for the time and day of the week.
If the time is less than four hours, the heater will switch on in the same operating mode as before the power
loss and will maintain all programmed parameters.
16
ECONOMY
button to change over to the Standby position.
TIME DISPLAYED = STANDBY
button again for ve seconds in order to change over to the Programming mode.
button again.
AUTOMATIC
1
2
3
4
5
6
7
and
buttons and then press the
and
buttons and then press the
and
buttons and then press the
ENGLISH
STANDBY (TIME)
button
button to con rm.
button to con rm.
Publicité
Table des Matières
