Declaration Of Conformity Ce - GiBiDi SERRA320 Instructions Pour L'installation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

SERRA320

MAINTENANCE

Periodically check the gate structure, in particular:

• Check functioning of the hinges;

•

Check that the leafs are correctly balanced. Excessive inclination of the leafs will result in faster wear of the

operator fastening brackets. Do the test by unlocking the operator and checking that the leafs do not move

on their own;

•

Check good functioning of the safety devices;

•

Unlock the operator and check that there are no points of friction along the entire travel;

•

Check that there is no dirt or debris on the worm screw, and if so, clean and then lubricate the worm screw with

lubricating grease.

•

Periodically check proper adjustment of the operator thrust force and the efficiency of the unlocking device for

manual operation (see the relative paragraph).

•

The safety devices installed on the system must be checked every six months.

Gi.Bi.Di. Srl reserves the right to change the technical data without prior notice in relation to product development.

MALFUNCTIONING

For any unresolved malfunction, cut the power to the system and call in a qualified technician (installer). In the

period when the gate is out of service, activate the manual unlocking device to allow manual opening and

closing.

The manufacturer:

declares that the products:

ELECTROMECHANICAL LINEAR OPERATORS SERRA320

are in conformity to the following CEE Directives:

•

Directive LVD 2006/95/CE and subsequent amendments;

• Directive EMC 2004/108/CE and subsequent amendments;

and that the following harmonised standards have been applied:

•

EN60335-1,

•

EN61000-6-2, EN61000-6-3

Date 23/10/2017