Cleaning And Maintenance; Safety Advice; Cleaning - Bartscher 700272 LN Mode D'emploi

Noise information
•
Sound emitted by the device during work are normal and do not indicate the
malfunction.
•
Gurgling and humming are the sounds of the cooling medium circulating in the
cooling circuit of the device.
•
Shorter and louder noise may be heard when the compressor is switched on.

6. Cleaning and maintenance

6.1 Safety advice

o Before beginning with repair or cleaning works make sure the device has been
disconnected from power supply.
o Do not use any acid agents and make sure no water ingresses the device.
o To protect yourself from electric shock, never immerse the device, its cables and
the plug in water or other liquids.
CAUTION!
The device is not suited for direct washing via water jets.
Therefore, you must not use any kind of pressure water jet for cleaning the device!

6.2 Cleaning

o Clean the device regularly.
o Protect the interior surface of the device and all plastic elements from grease, acids
and sauces. If they get dirtied, immediately wash the affected areas with warm water
and a mild cleaning agent.
o Use warm water with a mild cleaning agent to wash the interior and exterior
surface of the device. After washing, rinse with clean water. Never use hot water
to wash the device!
o Thoroughly wipe dry all washed surfaces.
o Regularly wash and wipe dry the door seal.
o Use the special cleaning element (fig. 10) for
periodical cleaning of the condensate drain hole.
- 40 -
fig. 10