Operation - Bartscher 700272 LN Mode D'emploi

5.3 Operation

Before use
•
Before the device operation clean it according to the instructions in section
6.2 „Cleaning".
•
Before placing the food or beverages in the device it should first obtain the required
temperature. It takes place approximately after 2 – 3 hours.
•
Connect the device to the single grounded socket. Set the required temperature.
Adjustment of temperature in the refrigerator for bottles 700272 (fig. 1)
Temperature in the refrigerator is adjusted with use of temperature control (1) (fig. 1).
Temperature may be adjusted in range
0
= compressor switched off.
Caution! The device is not connected to mains yet!
1
– the highest temperature (the weakest cooling)
7
– the lowest temperature (the strongest cooling)
NOTE!
When the products placed in the refrigerator are too cold, set the temperature
control to position
control to position
Adjustment of temperature in the refrigerator for bottles 700321 (fig. 3)
After switching the device on the green lamp illuminates.
Temperature in the refrigerator is adjusted with use of temperature control
the device (fig. 3). When the door is closed, the preset temperature may be read on
3
the display .
Temperature may be adjusted in range
0 =
compressor switched off.
Caution! The device is not connected to mains yet!
1
– the highest temperature (the weakest cooling)
5
– the lowest temperature (the strongest cooling)
- 38 -
0 – 7
1, 2, 3
or . When they are too warm, set the temperature
4, 5, 6, 7
or .
0 – 5
.
.
2
inside