Fracarro AMP9764 Mode D'emploi page 5

To get an easier access to the settings it is
possible to remove the cover:
(1) Open the cover a little bit
(2) Push the cover slightly towards the power
supply unit
(3) Remove the cover
To select the right voltage to feed the LNB, remove
the label and change the position of the dip-switch.
SETTINGS
To get access to the gain and slope adjustment:
(1) Unscrew the two safety screws
(2) Open the cover
The attenuators for the gain and slope adjustment are
accessible.
The position and specifications of each path are
described on the label.
3
label
5
3
2
1