Speaker Setup - Pioneer VSX-534 Mode D'emploi

• To perform the Initial Setup again after the setting is completed, press
select "7. Miscellaneous" - "Initial Setup", and press ENTER.
„ 1. Speaker Setup
1. Select the connected speaker configuration, and press ENTER.
Note that the image on the screen changes each time you select the number
of channels in "Speaker Channels".

Speaker Setup

Speaker Channels
Subwoofer
Height Speaker
Speaker Impedance
Select how many speakers you have.
2. The speaker combination selected in step 1 is displayed. "Yes" is displayed for
the selected speakers. If the setting is correct, press ENTER.
3. Select "Next" and press ENTER. Then a test tone is output from each speaker
to confirm the connection. Selecting each speaker with the cursors
output the test tone. Press ENTER after confirmation.
4. If there is no problem with the speaker connection, select "Next" and press
ENTER. To return to "Speaker Setup", select "Back to Speaker Setup" and
press ENTER.
„ 2. Full Auto MCACC
Place the supplied speaker setup microphone at the listening position. The unit
automatically measures the test tones output from each speaker, and sets the
optimum volume level for each speaker, the crossover frequencies, and the
distance from the listening position. This also automatically adjusts the equalizers
for the speakers, and enables correction of sound distortion caused by the
acoustic environment of the room.
• It takes between 3 and 12 minutes for calibration to be completed. Each
speaker outputs the test tone at high volume during measurement, so be
careful of your surroundings. Also, keep the room as quiet as possible during
measurement.
5.1 ch
Yes
- - -
6 ohms or above
Next
ENTER
Contents Connections
≫
• If you connect a subwoofer, check the power and volume of the subwoofer.
,
Set the subwoofer volume to more than half.
• If the power of this unit suddenly turns off, the wires in the speaker cables
have touched the rear panel or other wires, and the protection circuit is
working. Twist the wires again securely, and make sure they do not stick out of
the speaker terminals when connecting.
1. Place the supplied speaker setup microphone at the listening position, and
connect it to the SETUP MIC jack on the main unit.
SETUP MIC
When placing the speaker setup microphone on a tripod, refer to the
/ will illustration.
2. Confirm a test tone is output from the subwoofer and press ENTER.
3. Press ENTER. Then, test tones are output from each speaker, and the
connected speakers and the noise in the surrounding environment are
automatically measured.
4. The measurement results in step 3 are displayed. Select "Next", and press
ENTER. The test tones are output again. Then, the unit automatically sets the
optimum volume level, crossover frequency, etc.
5. When the measurement is completed, the measurement results are displayed.
You can check each setting using the cursors
ENTER to save the settings.
6. Disconnect the speaker setup microphone.
84
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
/ . Select "Save" and press
≫