Troubleshooting - Haussmann LS104 Guide De L'utilisateur

TROUBLESHOOTING

PROBLEM PROBABLE CAUSE
Motor does not Overload protection device disengaged to
start
protect the log splitter from being damaged
Log is improperly positioned
The sizes or hardness of the log exceeds
the capacity of the machine
Wedge cutting edge is blunt
Fails to split
logs
O l i e l a s k
Unauthorized adjustment was made on
max. pressure limiting screw. Lower
max pressure rating was set.
The log pusher Lack of hydraulic oil and excessive air in
moves jerkily, the hydraulic system
taking
unfamiliar
noise or
vibrating a lot
Air sealed in hydraulic system while
operating
Oil leaks
around Bleed screw is not tightened before
cylinder ram or moving the log splitter
from other
Oil drain bolt with dipstick is not tight.
points
Hydraulic control valve assembly and/or
seal(s) worn.
REMEDY SUGGESTED
Let motor cool down, and push the
button of the overload protection
device to re-start the motor
Refer to "Log splitter operation"
section for perfect log loading
Reduce the log size before splitting
it on the log splitter
Refer to "Sharpening
wedge" section to sharpen the
cutting edge.
L o c a e t e l a ( k ) s a n d c o n a t t c
Customer Service
Contact Customer Service
Check oil level for possible oil
refilling. Contact Customer Service
Loosen bleed screw by some
rotations before operating the log
splitter
Tight the bleed screw up before
moving the log splitter
Tighten the oil drain bolt with
dipstick
Contact Customer Service
25