Unpacking; Parts List; Features - Haussmann LS104 Guide De L'utilisateur

UNPACKING

WARNING! To prevent accidental starting that could cause possible serious
personal injury, assemble all parts to your log splitter before connecting it to
!
power supply. Log splitter should never be connected to power supply when
you are assembling parts, making adjustments, installing or removing
attachments, or when not in use.
Carefully remove all parts from the carton and place the log splitter on a level
work surface of the height not less than 23" (60 cm). Separate and check
against the list of loose parts.
WARNING! If any parts are missing, do not operate this machine until the
!
missing parts are replaced. Failure to do so could result in serious personal
injury.
Do not discard the packing materials until you have carefully inspected the log
splitter, identified all parts, and satisfactorily operated you new log splitter.
Note: If any parts are damaged or missing, do not attempt to plug in the power
cord and turn the switch on until the damaged or missing parts are obtained
and are installed correctly.

PARTS LIST

FEATURES

Check all loose parts from the box with the list below. Assemble
according to the instruction on the following pages.
1. Machine body assembly
2. Wheels
3. Supporting leg
4. Safety guard for ZHB hydraulic control lever
5. Rubber knob for ZHB hydraulic control lever
6. 4 sets of Bolts, elastic washers and flat washers
1. Before attempting to use, familiarize yourself with all the
operating features and safety requirements of your log splitter.
1. Wedge
2. Oil tank
3. Carrying handle
4. Supporting leg
5. Motor w/push switch & circuit breaker
6. Rubber feet
7. Wheel
8. ZHB hydraulic control lever
9. Safety guard for hydraulic control lever
10. Log pusher
11. Log retention brackets
21