Symbols; Important Safety Instructions - Haussmann LS104 Guide De L'utilisateur

SYMBOLS

Warning: Before carrying out any maintenance operation described in
this manual, disconnect the plug of the machine.
Warning: voltage as indicated on the rating plate.

IMPORTANT SAFETY INSTRUCTIONS

WORK AREA
1. Keep your work area clean and well lit. Cluttered benches and dark areas can
cause accidents.
2. Do not operate power tools in explosive atmospheres, such as in the presence
of flammable liquids, gases,or dust. Power tools create sparks which may ignite
the dust or fumes.
3. Keep bystanders, children, and visitors away while operating a power tool.
Distractions can cause you to lose control. Protect others in the work area from
debris such as chips and splinters. Provide barriers or shields as needed.
ELECTRICAL SAFETY
4. Avoid body contact with grounded surfaces such as pipes, radiators, ranges
and refrigerators. There is an increased risk of electric shock if your body is
grounded.
5. Don't expose power tools to rain or wet conditions. Water entering a power tool
will increase the risk of electric shock.
6. Handle the cord carefully. Never use the cord to carry the tools or pull the plug
from an outlet. Keep cord away from heat, oil, sharp edges or moving parts.
Replace damaged cords immediately. Damaged cords increase the risk of electric
shock.
7. When operating a power tool outside, use outdoor extension cords marked
"W-A" or "W". These cords are rated for outdoor use and reduce the risk of electric
shock.
PERSONAL SAFETY
8. Stay alert, watch what you are doing, and use common sense when operating
a power tool. Do not use tool while tired or under the influence of drugs,
alcohol, or medication. A moment of inattention while operating power tools may
result in serious personal injury.
9. Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep
your hair, clothing,and gloves away from moving parts. Loose clothes, jewelry,
or long hair can be caught in moving parts.
10. Avoid accidental starting.Be sure switch is off before plugging in. Plugging in
tools with the switch on invites accidents.
11. Remove adjusting keys before turning the tool on. A wrench or a key that is left
attached to a rotating part of the tool may result in personal injury.
12. Do not overreach.Keep proper footing and balance at all times. Proper footing
and balance enables better control of the tool in unexpected situations.
13. Use safety equipment. Always wear eye protection. Dust mask, non-skid safety
shoes, hard hat, or hearing protection must be used for appropriate conditions.
17