Specifications - Haussmann LS104 Guide De L'utilisateur

SPECIFICATIONS

Voltage
Frequency
Power input
No load speed
Insulation class
Protection degree
Max. splitting force (tons)
Max. ram travel
Diameter of ram
Log Capacity
Diameter
Length
Hydraulic oil capacity (L)
Electrical Safety
WARNING! Always check that the power supply corresponds to the voltage on
the rating plate.
WARNING! Connect the tool's power cord to a standard 120V±10%
(60Hz±1Hz) electrical supply which has protection devices of under-voltage,
over-voltage, over-current as well as a residual current device (RCD) which
maximum residual current rated at 30mA.
Replacing cables or plugs
If the machine's power cord or plug is worn or damaged, have it replaced
immediately. Discard any old parts. It is dangerous to insert the plug of a
loose cable in the wall outlet.
Using extension cables
1. As a supply for this machine always use an extension cord with conductor
of at least 2.5mm
extension is not longer than 32' (10 m). Excessively long cables or
inadequate section can cause voltage drops that prevent motor from
developing its full power.
2. Only connect your machine and/or extension cable to a grounded power
source.
3. This machine can be switched to the single-phase network (120V / 60Hz),
if you are in doubt about the earth of the electricity provisions, consult an
electrician first.
Grounding
In the event of an electrical short circuit, grounding reduces the risk of
electric shock by providing a path of least resistance to disperse electric
current. This machine is equipped with a power cord and a
equipment-grounding prong.
1. Reduce the risk of electrocution by keeping all connections dry and off the
ground. Do not touch plugs with wet hands. Failure to follow these warning
could result in serious injuries.
2. This machine must have a ground prong in the plug to help ensure that it is
grounded. Do not remove ground prong from plug to fit into a two-pronged
outlet! If the plug will not fit the outlet, have the proper outlet installed by a
qualified electrician.
20
LS104
120 V~
60 Hz
15 Amps
3,450 RPM
Class B
IP 54
5
14-1/2" (390 MM)
2-3/16" (55 MM)
2-10" (50-250 MM)
20-1/2" (520 MM)
2.8
and protected with a 20 Amp fuse. Be sure that the
2
!
!