External Components; Front Panel And Leds - Atlantis NetMaster G5P Mode D'emploi

 A PC can be connected to the Switch via a two-pair Category 3, 4, 5 UTP/STP
cables. The PC (equipped with a RJ-45 10/100Mbps phone jack) should be
connected to any port of the Switch.
 After plugging the selected cable to a specific port, the system uses auto-
negotiation to determine the transmission mode for any new twisted-pair
connection: If the attached device does not support auto-negotiation or has auto-
negotiation disabled, an auto-sensing process is initiated to select the speed and
set the duplex mode to half-duplex.

3. External Components

This section identifies all the major external components of the switch. Both the
front and rear panels are shown followed by a description of each panel feature.
The indicator panel is described in detail in the next chapter.

3.1 Front Panel and LEDs

Following is possible to check the meaning of each LED's status:
With the Auto-MDI function, you just need to plug-in the
network cable to the hub directly and no need to care if the
end node is NIC (Network Interface Card) or switches and
hubs.
18