J5create JUA190 Mode D'emploi page 13

USB DISPLAY ADAPTER
A. Connect all external display devices (monitor/ projector) to the VGA
connector of USB Display Adapters and switch power on.
B. Connect the USB Display Adapter into an available USB 2.0 port of a PC
or Notebook.
After Inserting an USB Display Adapter into a USB 2.0 port, the systems will
automatically start the installation procedure and the prompt message will
pop-up on the task bar.
The Device driver software was installed properly,
If you are going to install more USB Display Adapters, repeat step A& B or
USER MANUAL
12