Télécharger Imprimer la page

Twistorr 704 Fs On Board Controller Installation; Bottom Mounting - Agilent Technologies TwisTorr 704FS Mode D'emploi

Publicité

17
Technical Information

TwisTorr 704 FS On Board Controller Installation

TwisTorr 704 FS On Board Controller Installation

The controller can be mounted in two positions:
To install the controller execute the following procedures.

Bottom Mounting

See the following figure 43.
1
2
3
4
5
6
314/334
bottom mounting (as per the complete system);
side mounting.
Turn the pump upside-down;
Fix the plastic ring to the pump by means of the three socket
head screws M6, with the pump cable toward the pump body;
Fix the controller to the plastic ring by means of the three socket
head screws M5;
Turn the pump again;
Plug the main cable and connect the pump cable to the pump;
Connect the mating connector with the jumper on the interlock
signal to start the pump.
TwisTorr 704 FS User Manual / 87-901-051-01 (A)

Publicité

loading