Télécharger Imprimer la page

Agilent Technologies TwisTorr 704FS Mode D'emploi page 304

Publicité

17
Technical Information
TwisTorr 704 FS with On Board Controller
To fix the fan to the pump bottom:
1
2
3
4
5
Figure 30
304/334
Tear out the little rectangular sheet metal plate from the rest of
the fan.
Position this rectangular plate and the fan ensuring that the the 3
holes in the sheet plate are alined with the 3 holes in the pump
base as shown in the image 30.
Fix the bracket to the pump body using the plastic ring and
tighten the washers and the 3 screws M6x20 with the supplied
allen key.
Then fix the controller to the plastic ring and tighten the washers
and the 3 screws M5x90 with the supplied allen key.
Connect the fan to the P4 connector of the controller.
TwisTorr 704 FS User Manual / 87-901-051-01 (A)

Publicité

loading