Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH – Rolling screen installation and operation manual
WARNING: It 's absolutely forbidden to install the screen on mobile walls or unstable cables,the brackets must be applied on surfaces that ensure in the time your distance. When
installing the screen use plugs and screws suitable for the screen's weight and for the type of wall or ceiling on which the mount brackets are to be fixed, based on the following criteria
Screen width up to cm
Overall weight
GENERAL
1)
Important: make absolutely sure that the motor and the end cap of the pivot are correctly inserted into the roller, as transportation can sometimes cause them to become dislodged and to protrude
slightly from their original position.
WIDTH VIEWING AREA OF THE SCREEN <=3500 mm
WIDTH VIEWING AREA OF THE SCREEN >3500 mm
2)
The installation of these products has to be done compulsorily from qualified specialist. The fixing of all the installation brackets has to be done on fixed and permanent surface and structure, all the
installation done on mobile surface or mobile structure don't garantee safe using of the product.
3)
Take the brackets that are inside the accessories' KIT. Place one bracket on the side of the screen where the motor is and fasten it with two screws (picture 1). Place the other bracket on the side of
the pivot and secure it with the metal cotter pin (picture 2).
4)
Check the distance between the two brackets (picture 3). Afterwards remove the motor-side bracket by removing the two screws (picture 4) and then remove the pivot bracket by disengaging the
metal cotter pin and freeing it from the pivot itself (picture 5).
5)
Then mount the two brackets on the wall or ceiling at exactly the same distance previously checked, using suitable toggle bolts for the surface on which the screen is to be installed.
6)
Mount the screen on the brackets by inserting the screws on the motor and pivot sides, and blocking the pivot with the metal cotter pin provided.
INSTALLATION
WIDTH VIEWING AREA <=3500 mm
1
WIDTH VIEWING AREA >3500 mm E <=4500 mm
1
WIDTH VIEWING AREA >4500 mm
1
Made by Adeo Screen Sp. Z o.o. (Poland) Specifications are subject to change without notice. E&OE
Doc: BASIC Installation Manual rev2 | 12.06.2017
Please verify that you are working with the latest revision of this document before specifying your screen.
07 INSTALLATION INSTRUCTIONS
2
2
160
200
250
Kg 20
Kg 25
Kg 30
3
2
4
4
300
360
410
520
Kg 35
Kg 45
Kg 50
Kg 100
4
5
5
620
Kg 150
5
Page 10
Publicité
Table des Matières
