Specifications - Phonocar VM 030 Notice De Montage Et D'emploi

Specifications

General
Power supply 12V DC (11V-16V)
Test voltage 14.4V, negative ground
Maximum power output 50Wx4 channels
Continuous power output 25Wx4 channels
(4 ohm10% T.H.D.)
Suitable speaker impedance 4-8 ohm
Pre-Amp output voltage 4.0V (CD play mode: 1KHz,
0dB, 10K load)
Fuse 15A
Dimensions (WxHxD)
- Chassis 178x100x164mm
- Nose 170x105x21mm
Weight 3.0kg
Audio-in level 300mV
Subwoofer out 4.0V
7 INCH TFT LCD
Display resolution (dot) 1440(W) x 234(H)
Active area (mm) 154.08 x 86.58
Screen size (inch) 7.0 (Diagonal)
Dot pitch (mm) 0.107×0.370
Contrast ratio 300
Brightness 350 nits
FM Stereo Radio
Frequency range 87.5-108.0MHz (Europe)
87.5-107.9MHz (USA)
Usable sensitivity 8dBμ
Frequency response 30Hz-15KHz
Stereo separation 30dB (1KHz)
Image response ratio 50dB
IF response ratio 70dB
Signal/noise ratio >55dB
Note:
Specifications and the design are subject to change without notice due to improvements in technology.
AM(MW) Radio
Frequency range 522-1620KHz (Europe)
530-1710KHz (USA)
Usable sensitivity 30dBμ
Disc Player
System Disc digital audio system
Frequency response 20Hz - 20KHz
Signal/noise ratio >80dB
Total harmonic distortion Less than 0.20% (1KHz)
Channel separation >60dB
Video signal output PAL/NTSC/AUTO
Video output level 1±0.2V
Video signal input PAL/NTSC/AUTO
(original setting: AUTO)
Components
N.° 4 Machine screws M5x6 mm
N.° 1 Mounting bolt (50 mm)
N.° 2 Wire connector
N.° 1 Trim plate
N.° 1 Operating Instructions
N.° 1 Rubber cushion
N.° 1 Remote control
39
GB