Bosch BCS81 Unlimited Mode D'emploi page 60

Charging*
There are three different ways you can charge the bat-
tery – directly using the charging cable (
fitted docking station (
quick charger.
Charging with a charging cable only*
2*
Fig.
‡
To charge the vacuum cleaner, place it near to a so-
cket.
‡
Plug the charging cable into the connection point at
the bottom of the appliance.
‡
Plug the charging cable plug into the socket.
‡
The vacuum cleaner's indicator light will slowly flash
green as it charges.
Once the battery is fully charged, the indicator light
will remain continuously lit for a few minutes before
going out.
Disconnect the appliance from the mains briefly to
check it. The indicator will then light up green again.
‡
It is normal for the charging cable and vacuum clea-
ner to heat up and this is not a cause for concern.
‡
You can charge the vacuum cleaner whenever it is
not in use.
Fitting the docking station*
3*
Fig.
‡
Fit the docking station close to a socket.
‡
To do this, remove the front plate from the docking
station. Insert your finger into the docking station
from below, and push the front plate from the inside
and out of the locking mechanism. Use the screws
provided (or equivalent screws) to mount the do-
cking station on the wall.
‡
Insert the small connector on the charging cable into
the docking station from below, and then up and into
the preformed recess.
‡
Put the front plate back on and lock it in place to
secure the connection in place.
‡
Plug the charging cable's mains plug into the socket.
Charging in the docking station*
4*
Fig.
‡
Place the vacuum cleaner into the docking station
from above.
‡
The vacuum cleaner's indicator light will start to
flash slowly once the vacuum cleaner is connected
to the mains power supply via the docking station.
‡
The vacuum cleaner's indicator light will flash green
as it charges.
Once the battery is fully charged, the indicator light
will remain continuously lit for a few minutes before
going out.
Disconnect the appliance from the mains briefly to
check it. The indicator will then light up green again.
‡
It is normal for the charging cable and vacuum clea-
ner to heat up and this is not a cause for concern.
‡
You can charge the vacuum cleaner whenever it is
not in use.
60
2*
), in the
Fig.
3*
) or using an original
Fig.
Charging using the quick charger*
‡
To use the quick charger for charging, the battery
must be removed from the appliance (
‡
Please see the user manual provided for more infor-
mation on how the quick charger works.
Charge time
The charge time stated here may vary due to charge
status, battery temperature and battery age.
18V 2,5Ah
with the included 0,65A
charging cable
Via charging approx.
cable or 3,5 h
docking
station
(80%)**
Via charging approx.
cable or do- 4 h
cking station
(100%)***
Via Bosch Reference to quick charger User Ma-
quick char- nual
ger
Assembling the appliance
5
Fig.
‡
Fit the end of the suction tube onto the vacuum
cleaner's connection port and lock it in place.
‡
To release the suction tube, press the release button
and pull the suction tube down to remove it
6
Fig.
‡
Insert the end of the suction tube into the floor nozz-
le and lock it into place.
‡
To release the floor nozzle, press the release button
and pull the suction tube out of the floor nozzle.
Vacuum-cleaning
7
Fig.
The vacuum cleaner can be switched on and off by
pushing the On/Off switch on the handle in the direc-
tion of the arrow. When the vacuum cleaner is switched
on, the indicator light will be lit green.
* Depending on model
** Charge condition of the battery approx. 80%. The batte-
ry can be removed for immediate use.
*** Charging condition of the battery is 97%-100%
1
)
Fig.
18V 3,0Ah 18V 6,0Ah
with the
included
1,0A char-
ging cable
approx. approx.
4 h 5 h
approx. approx.
5 h 6,5 h