Bosch BGLS4 Série Mode D'emploi page 54

Masquer les pouces Voir aussi pour BGLS4 Série:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 55
23
Figure
Open the dust bag compartment lid.
a)Release the motor protection filter from the catch by
pulling it sideways, and pull it out in the direction of
the arrow.
b)Clean the motor protection filter by tapping out the
dirt.
c) If it is very dirty, the motor protection filter should be
rinsed.
The filter must then be left to dry for at least 24
hours.
d)After cleaning, refit the motor protection filter into
the appliance, lock it in place and close the dust bag
compartment lid.
Vacuum cleaner with micro-hygiene filter*
24*
Figure
Open the dust bag compartment lid.
a)Release the filter holder by moving the locking lever
in the direction of the arrow.
b)Remove the micro-hygiene filter.
c) The micro-hygiene filter can be rinsed out.
The filter must then be left to dry for at least 24
hours.
d)Remove the micro-hygiene filter. Insert the new
micro-hygiene filter into the appliance.
e)Insert the filter holder into the appliance and lock it
in place.
Vacuum cleaner with HEPA filter*
If your vacuum cleaner is equipped with a HEPA filter,
this must be replaced once a year.
25*
Figure
Open the dust bag compartment lid.
Unlock the Hepa* filter by moving the locking tab in
the direction of the arrow, and remove it from the
appliance.
Tap out the filter unit and rinse it under running
water.
Alternatively, the unit can be cleaned in a washing
machine at max. 30 °C using a gentle programme and
the lowest spin speed.
TIP: To protect other laundry items, put the filter unit
into a laundry bag.
Once the Hepa* filter has dried completely (at least
24 hours), insert it back into the appliance and lock it
in place.
Close the rear flap.
After vacuuming fine dust particles (e.g. gypsum, ce-
ment, etc.), clean the motor protection filter by tapping
it out or, if necessary, replace the motor protection filter
and exhaust filter.
54
Care
Figure
21
Always switch off the vacuum cleaner and disconnect it
from the mains before cleaning the vacuum cleaner.
The vacuum cleaner and plastic accessories can be
cleaned with ordinary plastic cleaner.
!
If required, the dust compartment can be vacuumed
out with a second vacuum cleaner or simply with a dry
duster/ dusting brush.
Subject to technical modifications.
Figure
21
Figure
21
* Depending on model
Do not use abrasive materials, glass-cleaning
agents or all-purpose cleaning products. Never
immerse the vacuum cleaner in water.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Bgbs4 sérieBgls40 série

Table des Matières