EIBENSTOCK EHR 15.2 SB Notice Originale page 12

Safety Instructions
Safe work with the machine is only possible if you read
this operating instruction completely and strictly follow
the instructions contained herein. In addition the general
safety instructions in the enclosed brochure have to be
observed. Take part in a practical introduction before the
first use. Save all warnings and instructions for future
reference.
If the connecting cable is getting damaged or severed during
the work, don't touch it but pull the mains plug immediately.
Never use the machine with damaged connecting cable.
The machine must neither be wet, nor be used in humid
ambient conditions.
Do not use the tool for mixing materials either in danger of explosion or
easily inflammable.
Do not mix food.
Modifications of the tool are prohibited.
Check the machine, cable and plug prior to every use of the tool. Have
damages eliminated only by an authorised specialist. Take care that the
tool is switched off when the plug is inserted into a connector socket.
In the open the machine only has to be used with a fault-current circuit
breaker with max. 30 mA.
Do not leave the machine running unattended.
Pull the mains plug, and check that the tool is switched off if it is left
without surveillance, for example for assembly and dismantling works, in
the case of stress dropping, for the insert or assembly of accessory parts.
Switch the machine off if it stops for whatever reason. So you will avoid
that it starts suddenly and not under supervision.
Do not use the machine if a part of the housing is damaged or in case of
damages on the switch, the connecting cable, or plug.
Power tools have to take an examination at regular intervals through an
authorised service workshop.
Do not touch rotating parts.
Persons under 16 years are not allowed to use the machine.
When working with the machine wear hearing protects and suitable
goggles, protective gloves and protective boots.
During use, always hold the machine with both hands and maintain
a safe stance. Pay attention to the reaction moment of the machine.
For further safety instructions, refer to the enclosure.
11