Agri-Fab 45-0345 Notice D'utilisation page 6

8. Assemble the hitch bracket to the front tongue using
two 3/8" x 1" hex bolts (B) and 3/8" nylock nuts (M).
Tighten. See fi gure 4.
9. Assemble the leg stand bracket to the front tongue using
two 5/16" x 1" hex bolts (C) and 5/16" nylock nuts (L).
Tighten. See fi gure 4.
LEG STAND
BRACKET
(C) 5/16" x 1"
HEX BOLT
FRONT
TONGUE
(L) 5/16" NYLOCK
NUT
FIGURE 4
10. Place the front tongue inside the rear tongue as shown
in fi gure 5. Fasten the tongues together using a 3/8"
x 4" hex bolt (A) and a 3/8" nylock nut (M). Tighten,
leaving the nut just loose enough that the tongues can
pivot freely. See fi gure 5.
11. Insert the 3/8" x 4" clevis pin (G) through the tongues
and secure with a 1/8" hairpin cotter (N), as shown in
fi gure 5.
FRONT
TONGUE
(G) 3/8" x 4"
CLEVIS PIN
FIGURE 5
ENGLISH
(B) 3/8" x 1"
HEX BOLT
HITCH
BRACKET
(M) 3/8" NYLOCK
NUT
(N) 1/8" HAIRPIN
COTTER
(M) 3/8"
NYLOCK NUT
(A) 3/8" x 4"
HEX BOLT
6
12. Assemble a wheel with the valve stem facing out onto
the axle. Assemble a hub cap (Q) by pressing or tapping
it onto the axle. Repeat on other end of axle. See fi gure
6.
WHEEL
(Q) HUB CAP
FIGURE 6
13. Turn the assembled tongue, wheel support and wheels
over to the upright position. Place the latch stand bracket
onto the tongue between the latch lock assembly and
the raised tab. Place the poly tray onto the wheel support
and latch stand bracket. Fasten the tray to the wheel
support using eight 5/16" x 3/4" truss head bolts (F) and
5/16" nylock nuts (L). Do not tighten yet. See fi gure
7.
14. Place the latch stand plate between the latch stand
bracket and the poly tray. See fi gure 7.
LATCH
STAND
PLATE
FIGURE 7
AXLE
(F) 5/16" x 3/4"
TRUSS HEAD
BOLT
(L) 5/16"
NYLOCK NUT
LATCH STAND
BRACKET