Greencut GTC300X Manuel D'utilisation page 73

INSERT THE FRONT WHEEL
1. Remove the wheel pins and align the wheel with the holes.
2. Place the pins, washers and pins to secure the wheel.
1
PLACE THE PROTECTIVE FINS
ATTENTION: The installation of the extended protective fenders is a safety measure and they must
be in place before using the motor hoe.
1. Place the fins aligned on the cutters to the support of the power tiller.
2. Place the screws by placing a rubber washer on the head of the screw.
3. Thread the screw by placing a metal washer over the thread.
1
PLACE THE CROSSBAR
1. Fasten the crossbar under the protective flaps.
2. Join it with the screws.
1
2
2
2
3
73
EN