Using The Remote Control - Lorell LLR33568 Manuel Du Propriétaire

5. Temperature setting (65 °F-85 °F). When the heater is in operation, press the
(Temperature Increase) or
lower the set temperature. The heater will automatically set the temperature to
default mode (85 °F), If the temperature is not set within 2 minutes after turning
on the heater.
6. Timer setting
a. Setting timer to turn on the heater.
When the heater is in "stand-by" mode (unit is plugged in but not operating),
press TlMER button to get your desired turn on time. which you want to
the heater is turned on. the "2H" icon will be displayed on the control panel
to indicate hat the heater will turn on after 2 hours. Press the timer button
repeatedly to automatically turn on the heater at any desired hour set in a
sequence of 2-4-6-8-10. The timer is adjustable up to 10 hours with a step rate
of 2 hours.
b. Setting the timer to turn off the heater.
Press the timer button once when the heater is in operation. The "2H" icon will
be displayed on the control panel to indicate that the heater will turn off within 2
hours. Press the timer button repeatedly to automatically turn off the heater with
a selected number of hours in a sequence of 2-4-6-8-10. The timer is adjustable
up to 10 hours with a step rate of 2 hours.
Timer will be canceled if you press the TIMER button when it is set to the
maximum hour.

USING THE REMOTE CONTROL

There are 6 keys that have the following functions:
1. Press this key to select the heat setting.
2. Temperature increase
3. Temperature decrease
4. Press to switch the heater on, press again to switch off
5. Press this key repeatedly to set the timer
CAUTION : Please dispose or recycle the battery according to municipal
or provincial laws
LLR33568_Assembly_Instructions.indd 5
(Temperature Decrease) button to raise or
5
5/26/15 5:33 PM