Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
Unpack your heater and find the wheel-holding plate and butterfly nuts between the
fins assemblies .
1.
Make sure the heater is unplugged and in the "OFF" position.
TURN THE HEATER UPSIDE DOWN.
2.
3.
Attach the wheel-holding plates onto the heater as Fig.1 shows . The U plate is
fixed between the last tow fins and the other one is fixed under metal control
box. Fix the castors to the vertical axis of both the wheel holding plates.
4.
Insert the butterfly nuts and tighten them securely.
5.
TURN THE HEATER UPRIGHT. Your heater is now ready to use.
Wheel-holding Plates
WARNING: Risk of fire. Do not operate heater without wheel assemblies
attached. Operate heater in upright position only (wheels on bottom,
controls on top). Any other position could create a hazardous situation.
Ensure that the surface beneath the heater is clean and free of any
obstructions. It is not recommended that this heater be placed on high-
pile carpeting or any other surface that impedes the flow of air underneath
the heater.
This heater include an a visual alarm to warn that parts of the heater are
getting excessively hot. If the alarm flashes, immediately turn the heater
off and inspect for any objects on or adjacent to the heater that may cause
high temperatures. DO NOT OPERATE THE HEATER WITH THE ALARM
FLASHING.
LLR33568_Assembly_Instructions.indd 3
Butterfly nuts
Roll caster
Fig. 1
3
Vertical axis
Wheel-holding plates
Metal control box
5/26/15 5:33 PM
Publicité
Table des Matières
