Novy 7800/16 Mode D'emploi Et D'installation page 16

Illumination
To activate the lights press button ④. The lights
will switch on at full power.
Lighting can be activated independently from the
motor.
Maintenance
Maintenance of the grease filter
The hood contains one metal filter which should
be cleaned twice a month.
Grease filter indication
After 20 cooking hours, the 4 speed indicator
lamps will start to blink during 5 minutes, this
indicates that the grease filter has to be cleaned.
When replacing the cleaned filter, you have to
reset the hood by pushing the – button during 5
seconds . If you don't reset, the speed indicator
lamps lights will continu blinking.
Access to the filter
Open the plate by pulling at the same time at
the right and left set. Pull the plate towards you.
When completely opened, the plate will stand on
itself. You can now access the grease filters.
The little gutter (A) must be cleaned after each
usage
Cleaning the filter:
- in the dishwasher
- manually: in a hot solution of water and a liquid
detergent. Rinse and allow to dry completely
Important! The previous instructions need to
be followed. If not an increased fire hazard may
occur.
Important! Always place the upper grease filter
with the handle downwards and the lower grease
filter wit the handle upwards.
You can close the hood by pushing the middle
part of the hinge upwards (1). Always support the
plate (2)
Maintenance of the hood
Please allow the lights to cool down sufficiently
before cleaning the hood.
Use a soft, wet cloth and a mild detergent to clean
the hood.
Never use aggressive, abrasive detergents or
sponges. Bleach will damage stainless steel.
The stainless steel surfaces can be treated with
Novy Inoxcleaner (906.060) after cleaning.
Replacement of the led ligths
In the event of a malfunction, you can contact
your (kitchen) supplier and/or the Novy Customer
Service Department. In order for the Customer
Service Department to reply quickly and precisely
you must to tell them which type of extraction
hood you have. The model number can be found
on a sticker on the interior of the extraction hood.
This is visible as soon as you take the filter out
of the extraction hood. You can write down the
model number here:
Model number: ............................
EN 16