Reverse Door Swing - Whirlpool W10261613A Instructions D'installation

REVERSE DOOR SWING

You can change your door swing from a right-side opening to a left-
side opening, if desired.
1. Place a towel or soft cloth on top of the dryer or work space to
avoid damaging the surface.
Remove the door assembly
1. Remove the 4 screws that hold the door hinge on the front panel
of the dryer.
A
A. Dryer front panel
B. Door assembly
2. Lay the door assembly on a flat, protected surface with the inside
(inner door assembly) facing up.
3. Remove the 6 Phillips head screws to release the outer door
assembly from the inner door assembly, as indicated below. See
illustration. It is important that you remove only the 6 indicated
screws.
4. Lift the inner door assembly off the outer door assembly.
5. Rotate outer door 180°.
B
180˚
Reverse hinge
1. Use a small flat-blade screwdriver to remove 2 plug strips from
the inner door. Slide the head of the screwdriver under the plugs,
being certain not to scratch the inner door surface. Lift up.
2. Remove the 4 screws that attach to the inner door hinge and
move the hinge to the other side. Reinstall the 4 screws.
A. Door hinge
3. Reinstall plug strips on opposite side of the inner door.
4. Check for fingerprints on the glass. Clean glass if necessary.
5. Place the inner door assembly inside the outer door assembly. To
fit correctly, the inner door assembly edge fits completely inside
the outer door assembly edge.
6. Reassemble the inner and outer door assemblies with the
6 screws.
Reverse the strike
1. Use a small flat-blade screwdriver to remove plug strip from the
dryer door opening. Slide the head of the screwdriver under the
plugs, being certain not to scratch the dryer surface. Lift up.
2. Remove the strike
A
13