Whirlpool W11389806B Guide D'utilisation page 20

3.
Connect remaining wires
Connect remaining wires under outer terminal block screws.
Tighten screws, tighten strain relief screws. Finally, replace the
terminal block cover and secure with the 4 hold-down screws.
Now, go to "Level Dryer."
3-Wire Power Supply Cord Strain Relief:
IMPORTANT: Use the strain relief supplied with the dryer.
Attach power supply cord to strain relief
Put power supply cord through the strain relief. Be sure that
the wire insulation on the power supply cord is inside the
strain relief. Do not further tighten strain relief screws at
this point.
3-Wire Power Supply Cord Connection
Use where local codes permit connecting cabinet-ground
conductor to neutral wire.
3-wire receptacle
(NEMA-type 10-30R)
Spade terminals with
upturned ends
20
3 prong plug
Ring terminals
1.
Connect neutral (center) wire
D
C
Connect neutral (center) wire (C) of power supply cord under
center terminal block screw (B). Tighten screw.
2.
Connect remaining wires
Connect remaining wires under outer terminal block screws.
Tighten screws, tighten strain relief screws. Finally, replace the
terminal block cover and secure with the 4 hold-down screws.
Now, go to "Level Dryer."
B