ETNA TFI8018 Mode D'emploi page 81

Masquer les pouces Voir aussi pour TFI8018:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATION
Following the end of the wash cycle
Once the wash cycle has completed, an audible signal will sound for
eight seconds. Switch the appliance off using the on/off button.
Open the door to the dishwasher. Wait a few minutes before unloading
the dishwasher. The dishes and cutlery will still be very hot immediately
following the end of the cycle. There is a chance that dishes may break
as a result of the heat. Moreover, the dishes dry better when allowed to
stand for a few minutes.
Do not open the dishwasher door during use!
Flood protection switch
Your dishwasher is fitted with a safety switch that prevents too much
water from running into the appliance. The safety switch closes the
inlet valve and instructs the dishwasher to pump out the surplus
water. If there is water in machine (due to too much water being fed in
previously, or as a result of a leak), this must first be removed before
the appliance is switched on again.
Warning!
Opening the door fully during the wash cycle is dangerous. You may be
splashed with hot water from the machine.
GB 9

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Tfi8048

Table des Matières