Safety Regulations; Layout And Items Supplied - EINHELL TC-LD 50 Instructions D'origine

Masquer les pouces Voir aussi pour TC-LD 50:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
Special information about the laser
Caution: Laser radiation
Do not look into the beam
Laser class 2
VORSICHT ! - LASERSTRAHLUNG !
Nicht in den Strahl blicken!
Laserspezifikation
Laser Klasse 2;
: 635-650 nm; P: < 1 mW
nach EN 60825-1
Never look directly into the laser path.
Never direct the laser beam at reflecting sur-
faces or persons or animals. Even a low out-
put laser beam can inflict injury on the eye.
Caution: It is vital to follow the work proce-
dures described in these instructions. Using
the equipment in any other way may result in
hazardous exposure to laser radiation.
Never open the laser module.
It is prohibited to carry out any modifications
to the laser to increase its power.
GB
The manufacturer cannot accept any liability
for damage due to non-observance of the
safety information.
Safety information on the batteries
Use of the batteries
Inserting the batteries when the laser is swit-
ched on can cause accidents.
If the equipment is not used correctly, the bat-
teries may leak. Avoid contact with the battery
fluid. If you come into contact with battery flu-
id, clean the affected body part with running
water. If you get battery fluid in your eyes,
seek immediate medical assistance.
Escaped battery fluid can cause skin irritation
and acid burns.
Never expose the batteries to excess heat
such as sunshine, fire or similar.
Never recharge batteries that are not suitable
for recharging. There is a risk of explosion!
Keep batteries away from children, do not
short circuit batteries or disassemble.
Seek a doctor's advice immediately if a batte-
ry is swallowed.
If necessary, clean the contacts on the
battery and equipment before inserting the
batteries.
Ensure that you insert the batteries the right
way round.
Remove flat batteries immediately from the
equipment. There is an increased risk of
leakage.
Always change all batteries in one go.
Insert only batteries of the same type, do not
use different types of batteries or used and
new batteries together.
Make sure that the equipment is switched off
after use.
Remove the batteries if the equipment is not
used over a longer period.

2. Layout and items supplied

2.1 Layout (Fig. 1)
1. Sensor
2. Laser
3. Display
4. Keypad
5. Swing-out stop
6. Battery compartment cover
- 18 -

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

22.700.80

Table des Matières