Safety Regulations; Layout And Items Supplied; Proper Use - EINHELL TC-MD 50 Instructions D'origine

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
Safety information on the batteries
Use of the batteries
•
Inserting the batteries when the laser is swit-
ched on can cause accidents.
•
If the equipment is not used correctly, the bat-
teries may leak. Avoid contact with the battery
fluid. If you come into contact with battery flu-
id, clean the affected body part with running
water. If you get battery fluid in your eyes,
seek immediate medical assistance.
•
Escaped battery fluid can cause skin irritation
and acid burns.
•
Never expose the batteries to excess heat
such as sunshine, fire or similar.
•
Never recharge batteries that are not suitable
for recharging. There is a risk of explosion!
•
Keep batteries away from children, do not
short circuit batteries or disassemble.
•
Seek a doctor's advice immediately if a batte-
ry is swallowed.
•
If necessary, clean the contacts on the
battery and equipment before inserting the
batteries.
•
Ensure that you insert the batteries the right
way round.
•
Remove flat batteries immediately from the
equipment. There is an increased risk of
leakage.
•
Always change all batteries in one go.
Anl_TC_MD_50_SPK1.indb 15 Anl_TC_MD_50_SPK1.indb 15
GB
•
Insert only batteries of the same type, do not
use different types of batteries or used and
new batteries together.
•
Make sure that the equipment is switched off
after use.
•
Remove the batteries if the equipment is not
used over a longer period.

2. Layout and items supplied

2.1 Layout (Fig. 1)
1. Display
2. Detection button
3. Selection buttons
4. ON/OFF button
5. Battery compartment cover
2.2 Items supplied
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Digital detector
•
Original operating instructions
•
Safety information

3. Proper use

The digital detector is designed for locating metal,
wood and live cables in walls, fl oors or ceilings.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
- 15 -
29.11.2016 09:45:19 29.11.2016 09:45:19