Set-Up And Operation; Safety Features - EUROM Safe-t-Heater Metal 2000 Manuel D'utilisation

Set-up and operation

Turn the thermostat dial to maximum (clockwise as far as possible).

Switch the heater on by turning the

control dial to one of the following
three positions: 800W, 1200W or
2000W. It is most economical to heat
the space at full power, then to switch
to a lower power to maintain the
temperature.
At all powers, the fan rotates at the

same speed; the difference lies in
the number of heating elements in
use.
Once the desired temperature is

reached, turn the thermostat dial
back slowly until you hear a click. The temperature is now set. The heater will
automatically switch on and off to maintain the set temperature. To set a higher
or lower temperature, turn the thermostat dial either clockwise or anticlockwise.
To switch the heater off, set the control dial to '0' (off). Unplug.


Safety features

Tipping safeguard
The heater is fitted with a tipping safeguard which automatically shuts off the
appliance if it inadvertently falls over. When the heater is returned to its upright
position, it will resume functioning as normal but, before reusing, switch off, unplug
and check for damage. Do not use the heater if it is damaged or malfunctioning,
but have it inspected/repaired!
Overheating safeguard
In case of internal overheating, the overheating safeguard will switch the heater off.
This may occur if the heater cannot give off enough heat or if it cannot draw in
enough fresh air. As mentioned above, this is generally caused by (partially) covering
the heater, obstructing the air intake and/or outlet grills or installing the heater too
close to a wall or something similar. When the overheating safeguard switches the
heater off, set the mode selector dial to '0' (off), unplug and allow the heater to cool
down. Remove and/or amend the cause of overheating and reuse the heater as
normal. If you cannot find a cause and overheating recurs, stop using the heater,
and take it in for inspection/repair.
27