Makita 9560CV Manuel D'instruction page 7

Speed adjusting dial
For model 9560CV, 9561CV, 9564CV, 9565CV only
2
001046
The rotating speed can be changed by turning the speed
adjusting dial to a given number setting from 1 to 5.
Higher speed is obtained when the dial is turned in the
direction of number 5. And lower speed is obtained when
it is turned in the direction of number 1.
Refer to the below table for the relationship between the
number settings on the dial and the approximate rotating
speed.
Number RPM (/min)
1
|
2
|
3
|
4
|
5
001279
CAUTION:
If the tool is operated continuously at low speeds
•
for a long time, the motor will get overloaded and
heated up.
The speed adjusting dial can be turned only as far
•
as 5 and back to 1. Do not force it past 5 or 1, or the
speed adjusting function may no longer work.
The tools equipped with electronic function are easy to
operate because of the following features.
Electronic function
Constant speed control
Possible to get fine finish, because the rotating
•
speed is kept constant even under the loaded
condition.
Additionally, when the load on the tool exceeds
•
admissible levels, power to the motor is reduced to
protect the motor from overheating. When the load
returns to admissible levels, the tool will operate as
normal.
Soft start feature
Soft start because of suppressed starting shock.
•
1. Speed adjusting
dial
1
2,800
|
4,000
|
6,500
|
9,000
|
10,500
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing side grip (handle)
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
002979
Screw the side grip securely on the position of the tool as
shown in the figure.
Installing or removing wheel guard
CAUTION:
When using
•
wheel/Multi-disc, flex wheel, wire wheel brush or
cut-off wheel, the wheel guard must be fitted on the
tool so that the closed side of the guard always
points toward the operator.
002980
Loosen the lever on the wheel guard. Mount the wheel
guard with the protrusion on the wheel guard band
aligned with the notch on the bearing box. Then rotate
the wheel guard around 180 degrees. Tighten the lever
to fasten the wheel guard. If the lever is too tight or too
loosen to fasten the wheel guard, loosen or tighten the
screw to adjust the tightening of the wheel guard band.
7
a depressed center
1. Wheel guard
1
2. Bearing box
3. Screw
4. Lever
2
3
4
grinding