Warning Indications - JVC GZ-MG555U Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Warning Indications

Indication
(Battery indicator)
SET DATE/TIME!
LENS COVER
HDD ERROR!
MEMORY CARD
ERROR!
CHECK CARD'S WRITE
PROTECTION SWITCH
VIDEO MANAGEMENT
FILE IS BROKEN. TO
RECORD/PLAYBACK
VIDEO, RECOVERY IS
REQUIRED. RECOVER?
CAN NOT READ EVENT
INFORMATION
RECORDING FAILURE
INCOMPATIBLE USB
DEVICE
54
Displays the remaining battery power.
High
As the battery power comes close to nil, the battery
indicator blinks. When the battery power is exhausted,
power turns off automatically.
Appears when the date/time is not set.
The built-in clock's rechargeable lithium battery is
discharged, so the previously set date/time is erased.
Connect the camera to an AC outlet using the AC adapter
for over 24 hours to charge the clock's lithium battery. Then
set the date/time.
Appears for 5 seconds after power is turned on in recording
mode if the lens cover is closed or when it is dark.
Remove the card once and insert it again. If the error is
not cancelled, replace the card with one that has been
guaranteed for correct operation.
Perform clean up to restore the capacity of the recording media.
It is recommended to run check disk regularly on the PC,
providing that there is no data on the hard disk of the camera.
Appears when you attempt recording when the write/erase
protection tab on the SD card is set to the "LOCK" position.
The video management fi le is broken. Recovery is required
to record or play back video fi les. Move the set lever to ¡ /
¢ to select [YES], then press down to recover the video
management fi le.
Appears when the event information cannot be read.
Performance of recording medium is poor. Use the Cleanup
function.
The writing speed of recording medium is slow, or the
recording medium is corrupted. Use an SD card that is
guaranteed to operate.
The recording medium was subjected to vibrations or jolts.
Be careful not to subject the recording medium to vibrations
or jolts.
Appears when the recording medium is full and recording
is not possible. Delete unnecessary fi les, or replace the SD
card.
Appears when an incompatible USB device is connected to
the camera.
Appears when a DVD burner that is switched off is
connected. If you want to use the DVD burner, switch the
power on.
Meaning/Action
Exhausted
13
12
15
50
30
50
15
30

Publicité

Table des Matières
loading

Table des Matières