Mounting And Operation - Bosch AQT 42-13 Notice Originale

Typically the A-weighted noise levels of the product are:
– Sound pressure level
– Sound power level
– Uncertainty K
Wear hearing protection!
Vibration total values a (triax vector sum) and uncertainty K determined
h
according to EN 60335-2-79
– Vibration emission value a
h
– Uncertainty K

Mounting and Operation

Action
Delivery scope
Adjusting the Handle
Connecting high pressure gun
to lance
Connecting high pressure wa-
ter supply hose/nozzle
Tube Assembly
Connecting to the water supply
Switching On and Off
Clean the water filter
Clean nozzle
Gun storage
Gun/lance/nozzle stored during
work breaks
Placing hose into the hose
holder
Storage
Selecting Accessories
Switching on
For Your Safety
Warning: Switch off, remove plug from
mains before adjusting, cleaning or if cable
is cut, damaged or entangled.
The operating voltage is 230 V AC, 50 Hz (for non-EU coun-
tries 220 V, 240 V as applicable). Contact your Bosch Ser-
vice Centre for details. If in doubt contact a qualified electri-
cian or the nearest Bosch Service Centre.
If you want to use an extension cable when operating your
high pressure washer, only the following cable dimensions
should be used:
2
– 2.5 mm – max length 25 m
Note: If an extension cable is used it must be earthed and
connected through the plug to the earth cable of your supply
network in accordance with prescribed safety regulations.
Bosch Power Tools
If in doubt contact a qualified electrician or the nearest
Bosch Service Centre.
Figure Page
A 281
B 281
and intended for outdoor use.
C 282
The connections (plugs and sockets) should be kept dry and
off the ground.
For increased electrical safety use a Residual Current Device
D 282
(RCD) with a tripping current of not more than 30 mA. Al-
ways check your RCD every time you use it.
E 283
If the supply cord is damaged, it must be replaced by a
F 284
Bosch Service Centre.
G 285
For products not sold in GB:
H 285 Warning: For your safety, it is required that the plug at-
tached to the product is connected with the extension cord.
I 285
The coupling of the extension cord must be protected
J 286
against splash water, be made of rubber or coated with rub-
K 286 ber. The extension cord must be used with a cable strain re-
lief.
To prevent damage to the appliance, do not allow it to oper-
L 287
ate dry.
Products sold in GB only:
M 287
Your product is fitted with an BS 1363/A approved electric
N 288
plug with internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place by an au-
thorised customer service agent. The replacement plug
should have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains
socket elsewhere.
Operation
Starting
Attach water supply hose (not supplied) to the mains water
supply and machine.
Connect the product to the mains supply ensuring that the
mains switch is in the off position.
Open water tap.
3 600 HA7 3..
dB(A)
dB(A)
dB
2
m/s
2
m/s
WARNING! Inadequate extension cables can
be dangerous. Extension cable, plug and
socket must be of watertight construction
F 016 L81 843 | (15.02.2019)
English | 17
81
94
2
2.0
1.5