Functions - AEG 97024 Mode D'emploi

No. Description
11 LED (red) 2 A / 6 A / 10 A
Terminal connection cable (+)
12
with clamp (red)
Terminal connection cable (-)
13
with clamp (black)
14 Power cable with power plug
15 LED Power
16 LED Full
17 LED Charge
18 LED Error
19 handle

Functions

The charger is equipped with a microprocessor
(MCU - Micro Computer Unit) and features fully
automatic charging-, diagnostic-, emergency- and
maintenance functions. After selecting the battery
type connected (12 V or 24 V) the battery charger
will recognise the battery capacity and the battery
condition and calculate the required charging pa-
rameters (charging voltage, charging current). This
allows for efficient and safe charging. If the wrong
battery voltage is set or the battery is defective, it
will not charge and the "Error" LED (18) will light up
(also see "Troubleshooting").
The "trickle charge" function allows the charger
to be permanently connected. A full charge will be
maintained.
Function
Displays the selected charging current (in charging mode only).
Switch with the button (2).
To connect the charger to the battery (+ terminal)
To connect the charger to the battery (- terminal)
to supply power.
lights up when the power cable is plugged in.
lights up when the battery is fully charged.
lights up during charging.
lights up if connected incorrectly.
An alarm will also sound.
for carrying the charger.
The 'Power supply' function allows the charger to
provide a bridging power supply. While changing
the batteries, the charger provides the vehicle with
electricity and no data is lost.
The 'Automatic temperature adjustment' function
measures the ambient temperature and adjusts
the charging phase according to the ambient
temperature.
English 23