ESAB M3 plasma EPP-202 Mode D'emploi page 50

Interface Adaptor Box
The Interface Adaptor Box is required when using a EPP-202/362 in place of a EPP-201/360.
The box has 2 LED indicators. The indicator on the left represents the "10s" digits, the indicator on the right rep-
resents the "1s" digits. Count each flash of the indicators to determine the help code number. The indicators will
flash in sequence, pause, and repeat. Example: if the left indicator flashes 2 times, pauses and repeats, and the
right indicator flashes 4 times, pauses and repeats, your help code would be 24. See help code lists for explana-
tion.
Installation: Remove existing connections from the EPP-201/360 and connect to the Interface Adaptor Box. Use
the existing cables supplied and currently used on your EPP-201/360. The E-stop connector has either a 2-pin or
4-pin connector, determine which connector your equipment has and connect to the appropriate connector.
The paralleled power source connections are not supported with the EPP-202/362 applications.
Additionally, the internal coolant circulator must be used with the EPP-
202/362, thus any external coolant circulator should be disconnected.
Interface Adaptor Box top view
50 50
TROUBLESHOOTING
LED indicators
E-stop connection (2-pin or 4-pin)
Connection from Remote Control on
the EPP-201/360 connects here
Connections made on the front
of the EPP-362/362
Connect to Analog Interface on the
EPP-362/362
Connect to J1 (RAS) on the EPP-362/362