Automatic Switch-Off; The Heat Setting; Automatic Heat Up - AEG IKE64453IB Notice D'utilisation

5.2 Automatic Switch Off
The function deactivates the hob
automatically if:
• all cooking zones are deactivated,
• you do not set the heat setting after you
activate the hob,
• you spill something or put something on
the control panel for more than 10
seconds (a pan, a cloth, etc.). An acoustic
signal sounds and the hob deactivates.
Remove the object or clean the control
panel.
• the hob gets too hot (e.g. when a
saucepan boils dry). Let the cooking zone
cool down before you use the hob again.
• you use incorrect cookware. The symbol
comes on and the cooking zone
deactivates automatically after 2 minutes.
• you do not deactivate a cooking zone or
change the heat setting. After some time
comes on and the hob deactivates.
The relation between the heat setting and
the time after which the hob deactivates:
Heat setting
, 1 - 3
4 - 7
8 - 9
10 - 14

5.3 The heat setting

To set or change the heat setting:
Touch the control bar at the correct heat
setting or move your finger along the control
bar until you reach the correct heat setting.
5.4 Using the cooking zones
Place the cookware in the centre of the
selected zone. Induction cooking zones
adapt to the dimension of the bottom of the
cookware automatically.
The hob deactivates
after
6 hours
5 hours
4 hours
1.5 hour
You can cook with large cookware placed on
two cooking zones at the same time. The
cookware must cover the centres of both
zones but not go beyond the area marking. If
the cookware is located between the two
centres, Bridge function will not be activated.
5.5 Bridge
The function operates when the
pot covers the centres of the two
zones.
This function connects two cooking zones
and they operate as one.
First set the heat setting for one of the
cooking zones.
To activate the function for left / right
cooking zones: touch
change the heat setting touch one of the left /
right control sensors.
To deactivate the function: touch
The cooking zones operate independently.

5.6 Automatic Heat Up

Activate this function to get a desired heat
setting in a shorter time. When it is on, the
zone operates on the highest setting in the
beginning and then continues to cook at the
desired heating setting.
To activate the function the
cooking zone must be cold.
/ . To set or
/ .
ENGLISH 11