Cleaning The Cylinder Area; Replacing The Fuel Filter; Replacing/Cleaning The Spark Arrester Screen - Dolmar PS-460 Manuel D'emploi Et De Sécurité

14
B
15
C
D

Cleaning the cylinder area

After prolonged use, dirt and sawdust can build up on the cylin-
der and cause the engine to overheat. The cylinder fin cleaner
helps remove deposits between the cylinder fins and between
the cylinder and the mounting plate.
Remove cover.
Remove the fan housing.
CAUTION: To prevent eye injury, always wear eye protection
when cleaning the filter with compressed air!
The entire area (14) can now be brushed clean or cleaned with
compressed air.
A bottle brush can come in handy for cleaning out the cylinder
ribs.
With the cyinder ribs cleaner (only in delivery for model PS-
500 S), clean out the area between the cylinder ribs and bet-
ween the cylinder and the mounting plate.
Do not use force. Be careful not to damage the short-circuit
wire and the ignition wire.

Replacing the fuel filter

The felt filter (15) of the fuel filter can become clogged.
It is recommended to replace the fuel filter once every
three months in order to ensure unimpeded fuel flow to the
carburetor.
To remove the fuel filter for replacement, pull it out through
the tank filler neck using a piece of wire bent at one end to
form a hook.

Replacing/cleaning the spark arrester screen

The spark arrester screen should be checked and cleaned
regulary.
16
Loosen the screw (16) and remove the spark arrester screen
(17).
Caution: Do not use sharp or pointed objects for screen cleaning.
Damaged or misformed screen wires may result.
17
Reassembly the spark arrester screen and tighten the screw.
STOP
35