Connections (Notifications); Connecting To An Antenna Or Cable - LG 43LJ550M Guide De Configuration Rapide

43LJ550M
Model 43LJ5500
43LJ5550
VESA (A x B) 200 x 200
Standard screw
M6
Number of screws 4
Wall mount bracket LSW240B
(optional) MSW240
A
B
• Remove the stand before installing the TV
on a wall mount by performing the stand
attachment in reverse.
• When using the wall mount, it is recommended
that you apply a piece of tape over the Stand
holes to prevent dust and bugs from entering
the holes. (Depending upon model)
Stand hole

Connections (Notifications)

49LJ550M
49LJ5500
49LJ5550
You can connect various external devices to the TV.
55LJ550M
Supported external devices are: HD receivers, DVD
55LJ5500
players, VCRs, audio systems, USB storage devices,
55LJ5550
PC, gaming devices, and other external devices. For
300 x 300
more information on external device's connection,
M6
refer to the manual provided with each device.
4
• If you record a TV program on a DVD recorder or
LSW350B
VCR, make sure to connect the TV signal input
MSW240
cable to the TV through a DVD recorder or VCR.
For more information about recording, refer to
the manual provided with the connected device.
• The external device connections shown may
differ slightly from illustrations in a manual.
• Connect external devices to the TV regardless
about the order of the TV port.
• If you connect a gaming device to the TV, use the
cable supplied with the gaming device.
• Refer to the external equipment's manual for
operating instructions.
• In PC mode, there may be noise associated
with the resolution, vertical pattern, contrast
or brightness. If noise is present, change the PC
output to another resolution, change the refresh
rate to another rate or adjust the brightness and
contrast on the Picture menu until the picture
is clear.
• When connecting via a wired LAN, it is
recommended to use a CAT 7 cable.
• The TV may be capable of operating without
a set-top-box from a multichannel video
programming distributor (MVPD).

Connecting to an Antenna or Cable

Connect an antenna, cable, or cable box to watch
TV while referring to the following. The illustrations
may differ from the actual items and an RF cable is
optional.
• Make sure not to bend the copper wire of the RF
cable.
• Complete all connections between devices, and
then connect the power cord to the power outlet
to prevent damage to your TV.
• Use a signal splitter to use 2 TVs or more.
• DTV Audio Supported Codec: MPEG, Dolby
Digital.
Copper wire
7