AEG HK654070IB Notice D'utilisation page 15

• To replace the damaged mains cable
use the following (or higher) mains
cable type: H05V2V2-F T min 90°C.
Speak to your local Service Centre.
8.4 Attaching the seal to the
rabbet
1. Clean the rabbets in the worktop.
2. Cut the supplied seal stripe into 4
stripes. The stripes must have the
same length as the rabbets.
8.5 Assembly
min.
500mm
3. Cut the ends of the stripes at an
4. Attach the stripes to the rabbets. Do
After you assemble the hob, seal the
remaining gap between glass ceramic
and the worktop with silicone. Make sure
the silicone does not get under the glass
ceramic.
min.
50mm
min.
28 mm
angle of 45°. They should fit in the
corners of the rabbets accurately.
not extend the stripes. Do not bond
ends of stripes one over another.
R10mm
R5mm
7mm
12mm
490 +1 mm 560 +1 mm
514 +1 mm
min.
20 mm
ENGLISH 15
min. 55mm
584 +1 mm
min.
12 mm