Start Surveillance - Dörr SnapShot Limited 5.0S Notice D'utilisation

5. The picture can be viewed with a Laptop or PC. There are 2 options:
a) Connect the camera directly to computer using an optional USB cord. Plug the USB cord into the Mini USB port
(11) of the camera and connect with USB port at your computer.
b) Remove the memory card from the camera and read out pictures with an external card reader (optional).
6. We recommend to direct the camera in a way that the object will be in the center of the picture. You may have to re-adjust the
camera and take another test shot.
Tip To change the camera angle you can use e.g. a small wooden wedge between camera and trunk.
7. Once the camera position is correct, the fixing belt can be tightened to hold the camera firmly
8. Switch the camera off after test shooting.

START SURVEILLANCE

Slide the On/O button (9) to "ON" position and close the camera housing. After 15 - 30 seconds camera is ready and it records
according to your settings and upon movement.
CAMERA CHECK UP
Options to check if the camera has taken pictures:
1. Open the camera housing and turn o camera. After about 2 seconds slide the On/Off button (9) to "SETUP" position.
2. The LCD display (5) shows the start screen. The lower line shows the number of pictures taken and the remaining memory.
Example: [0034/1846].
3. It is recommended to check the battery status as well. When capacity goes down, it will be more diffcult to achieve correctly
illuminated night shots. In case of doubt, replace batteries by new ones.
20