Install The Hood (Ez1 Bracket) - Venmar VBLDN1 Manuel D'installation, D'utilisation Et D'entretien

Les langues disponibles

OTE:

The following procedure applies to both frame or frameless cabinet installations.

1 ] Run house power cable between service panel and hood location.

2 ] There are 2 pairs of recessed holes on each side of the top of the hood (on rear: A and B,

on front C and D on illustration below); these holes allow the range hood to hang on the

brackets (previously installed).

HORIZONTAL EXHAUST INSTALLATION ONLY

3 ] Temporarily hang the hood on the brackets using its (2) recessed REAR HOLES (A and B).

While holding the hood, run the house power cable into the hood through the strain relief

previously installed in step 6 on page 11.

4 ] Unhook the rear holes from the brackets and hang the hood using its (2) recessed FRONT

HOLES (C and D). While holding the hood, go to step 6.

VERTICAL EXHAUST INSTALLATION AND NON-DUCTED INSTALLATION ONLY

5 ] Hang the hood on the brackets using the (2) recessed FRONT HOLES (C and D). While

holding the hood, tighten an appropriate strain relief, 1/2" diameter (not included) to the

power cable, then insert the strain relief in the knockout hole.

6 ] Connect ductwork to hood and use metal foil duct tape to make joints secure and air-tight.

Make sure the damper assembly (or round duct plate) enters the ductwork and that the

damper opens and closes freely.

NOTE: See final installation steps on next page.

Install the Hood (EZ1 Bracket)

DUCTED INSTALLATION ONLY

Table des Matières