Speed Levels; Headless Mode - Hama Airdevil Mode D'emploi

Left/right
• If the drone continually tilts to the right during the flight,
briefly push the Tweaking button (11) to the left. Repeat
this step until the drone is aligned.
• If the drone continually tilts to the left during the flight,
briefly push the Tweaking button (11) to the right.
Repeat this step until the drone is aligned.
Forwards/backwards
• If the drone continually tilts forwards during the flight,
briefly push the Tweaking button (10) downwards.
Repeat this step until the drone is aligned.
• If the drone continually tilts backwards during the flight,
briefly push the Tweaking button (10) upwards. Repeat
this step until the drone is aligned.
Turning left/right
• If the drone continually tilts to the left during the turn,
briefly push the Tweaking button (4) to the right. Repeat
this step until the drone is aligned.
• If the drone continually tilts to the right during the turn,
briefly push the Tweaking button (4) to the left. Repeat
this step until the drone is aligned.

7.4 Headless mode

Note – Headless mode
• If Headless mode is activated, the control of the drone
when sending commands is guided by the position
of the pilot.
• If you move the right control lever (12) upwards/
downwards, the drone flies away from you / towards
you.
• If you move the right control lever (12) to the left/
right, the drone flies left/right.
• The flight direction and position of the drone is
irrelevant in this mode.
• Make sure that you remain in the position that you
take during calibration with the remote control.
• Position the drone directly in front of you so that its
fuselage points away from you and in the desired flight
direction.
• Hold the remote control such that it points to the rear
part of the drone in a direct line.
• Press and hold the Headless mode button (8) for
approximately 3 seconds to activate the Headless mode.
• The Headless mode is indicated through a signal tone
and fast flashing of the drone's LED indicator (6).
• If you press the Headless mode button (8) again, the
mode is deactivated. A signal tone will sound and the
drone's LED indicator (6) is again constantly lit.
11

7.5 Speed levels

Note
• Three speed levels (low, medium, high) can be
selected.
• When you switch on the product, the drone is set to
the low speed level.
• Experienced pilots can increase the drone's speed by
selecting the medium or high speed level.
• Press the speed controller (6) to change the speed level.
7.6 Resetting the drone
Note
• Frequent/incorrect trimming can result in
misalignment of the drone.
• This can be eliminated by resetting the control to the
neutral position.
• If the landing/standing legs (3) are damaged, precise
alignment of the control is not possible.
• In this case, the alignment must not be reset to
the neutral position. This would influence the flight
behaviour of the drone.
• Position the drone on a flat horizontal surface.
• If necessary, pair the drone with the remote control. (See
Section 7.1)
• Move both control levers at a 45° angle towards the
bottom left (as shown in the diagram) and hold them
there for approximately 3 seconds. The drone's LED
indicator (6) lights up.
• Then move both control levers at a 45° angle towards
the bottom right (as shown in the diagram) and hold
them there for approximately 3 seconds. The drone's LED
indicator (6) lights up.