Flight Control - Hama Airdevil Mode D'emploi

Warning – rechargeable battery
• Only use suitable charging devices with USB
connections for charging.
• As a rule, do not use charging devices or USB
connections that are defective and do not try to repair
them yourself.
• Do not overcharge the product or allow the battery to
completely discharge.
• Avoid storing, charging or using batteries in extreme
temperatures.
• When stored over a long period of time, batteries
should be charged regularly (at least every three
months).
• After every flight and before charging, allow the
motors and the battery to completely cool!
• Continually monitor charging!
• Stop charging immediately if the battery becomes hot
and/or deformed!
• Use a heat-resistant, fire-proof surface for charging!
Note – charging/battery capacity
• It takes approximately 1 hours to fully charge the
battery.
• The battery comes partially charged. Initial charging
may therefore take less time.
• After a charging time of 60 minutes, the flying time is
approximately 8-10 minutes.
• The actual flying time varies according to use of the
product, the settings and ambient conditions (for
example, temperatures below 5°C and above 25°C
reduce battery capacity).
7. Flight mode
7.1 Pairing the drone with the remote control
• Place the drone on a level surface.
• Move the slide switch (7) on the drone to the ON
position. The LEDs (5) begin to flash.
• Press the on/off switch (12) to switch on the remote
control.
• Move the left control lever (2) all the way up.
• Then move the left control lever (2) all the way down.
• Two signal tones are emitted to confirm the pairing. The
drone's LED indicator (5) and that of the remote control
(12) are now permanently lit.
9

7.2 Flight control

• Press the Start button (7) on the remote control to start
the rotors.
Note
• Control the drone only with minimal movements
of the control levers so as to ensure smooth flight
behaviour.
• Avoid jerky movements. The drone could get out of
control.
• The direction specifications assume that the drone is
in front of you and facing forward, or is in Headless
mode (see Section 7.4).
Taking off and climbing
Note
• The drone is equipped with an altitude assistant.
The altitude that is set using the remote control is
maintained automatically.
• To launch your drone or to gain altitude, move the left
control lever (2) on the remote control upwards.
Landing and descending
• To land the drone or to descend to a lower altitude,
move the left control lever (2) on the remote control
downwards.
• Alternatively, while the drone is in flight, press the
automatic landing button (9) to have the drone
automatically land.
Left control
Left control