Hama Airdevil Mode D'emploi page 6

• Note that special, extended regulations and prohibitions
on climbing model aircraft apply in large cities such as
Berlin, Hamburg, Cologne, etc.
• Respect the personal and property rights of others! Do
not use camera drones to capture images of other people
without first asking for their permission.
• Do not fly over third-party property!
• Do not fly near people, waters, radio masts or power
lines, and do not frighten animals with the product!
• In areas where you are allowed to operate and climb
a model aircraft, observe a maximum flying altitude of
100 m.
• In areas where you are allowed to operate and climb a
model aircraft, only fly within the range of vision.
• In general, the following applies: Do not disturb your
fellow human beings and your environment through
actions that go against general decorum and/or that you
yourself would consider to be a nuisance.
• The pilot in command of the drone is, in principle, liable
for all damages that may be caused during a flight.
• Keep an eye on the battery of the drone. Land
immediately if the battery loses power, so as not to
crash.
• Before flying, make sure the weather conditions are
suitable.
• Always anticipate hazards when flying! Pay attention to
both the drone and your environment.
• Do not use any technical devices to extend the range of
vision.
• Unmanned aviation systems and model aircraft are
obliged to give way to manned aircraft and manned
balloons.
6. Getting started
Note
• Before getting started, familiarise yourself with the
product and its operation, ideally under the guidance
of a person who is experienced with similar products.
• The packaging can be used to store the product; it
protects the product from dust and damage.
6.1 Remote control – inserting the batteries
• Open the battery compartment (13) and insert four
AA batteries, observing correct polarity. Then close the
battery compartment cover.
6.2 Model aircraft – charging the battery
Note
• The battery, drone and charging adapter included in
the delivery go together and should always be used in
combination.
• Fully charge the battery of the drone before using it for
the first time.
• Open the battery compartment cover of the battery bay
(4) on the underside of the drone.
• Remove the battery of the drone.
• Connect the supplied USB charging cable to the battery.
• Connect the unused plug on the USB cable to an
available USB port on your computer or another suitable
USB charger. Please refer to the operating instructions for
the USB charger used.
• The LED indicator of the USB charging plug is lit red
during charging. When the battery is fully charged, the
LED indicator goes out.
• Remove the connection cable from the battery bay (4) of
the drone.
• Connect the charged battery to the connection cable.
• Put the connected battery back into the battery bay (4)
and then close the battery compartment cover.
8