Closing The Door - Electrolux UG0985RE Notice D'utilisation

54 www.electrolux.com
Problem
The compressor does not
start immediately after
pressing the FastFreeze,
or after changing the tem‐
perature.
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
Door does not open easily. You attempted to re-open
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
Possible cause
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
This is normal, no error
has occurred.
The FastFreeze function is
switched on.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been opened
often.
The FastFreeze function is
switched on.
There is no cold air circula‐
tion in the appliance.
the door immediately after
closing.

7.2 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
Solution
Wrap the food products
better.
Refer to "Operation" chap‐
ter.
The compressor starts af‐
ter a period of time.
Switch off FastFreeze
manually, or wait until the
function resets automati‐
cally to set the tempera‐
ture. Refer to "FastFreeze
function"
Set a higher/lower temper‐
ature.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if nec‐
essary.
Refer to "FastFreeze func‐
tion".
Make sure that there is
cold air circulation in the
appliance.
Wait a few seconds be‐
tween closing and re-open‐
ing of the door.
to assembly instructions.