Hitachi DH 40MEY Instructions De Sécurité Et Mode D'emploi page 15

4. Drilling holes....For drilling metals and wooden
materials
(1) 13mm drill chuck
(13VLD-D)
Code No. 321813
5. Bolt plaching operation with Chemical Anchor (Rotation
+ Hammering)
(Standard socket
on the market)
Square dimensions of the side
of the socket installation
1/2" (12.7 mm)
3/4" (19.0 mm)
6. Crushing (Hammering)
(1) Bull point
Overall length
11" (280 mm)
15-3/4" (400 mm)
7. Groove digging and edging (Hammering)
(1) Cold chisel
Overall length
11" (280 mm)
15-3/4" (400 mm)
+
(2) Chuck adaptor
(SDS max shank)
Code No. 313468
(3) Chuck wrench
Code No. 930515
+
(1) Chemical Anchor Adaptor
(SDS max shank)
Code No.
313469
313470
Code No.
313471
313472
Code No.
313473
313474
8. Asphalt cutting (Hammering)
(1) Cutter
Overall length
15-3/4" (400 mm) 1-31/32" (50 mm)
9. Digging
(1) Scoop
Code No. 313476
10. Surface Roughing (Hammering)
+
(1) Bushing Tool
Code No. 313477
(2) Shank
Overall length
8-21/32" (220 mm)
11. Tamping (Hammering)
+
(1) Rammer
Code No. 313478
(2) Shank
Overall length
8-21/32" (220 mm)
12. Syringe (for chip removal)
Code No. 320859
13. Hammer grease A
1.1 lbs (500 g) (in a can) Code No. 335781
0.13 lbs (60 g) (in a tube) Code No. 335782
NOTE
Specifications are subject to change without any
obligation on the part of the HITACHI.
English
Width Code No.
313475
Code No.
313479
Code No.
313479
15