SEVERIN KA 9582 Mode D'emploi page 16

Trouble-shooting
Problem
The appliance does not
work, and all buttons are
flashing.
No water/steam coming out. Water container not filled.
Water dripping from the
steam tube.
Milk is not properly frothed.
No espresso coming out.
The buttons are fast-
flashing.
No espresso coming out.
No Crema.
Espresso too weak.
Espresso too strong.
Espresso spills from the filter
holder rim.
16
Cause
The rotary control is set to
Water container not fitted properly.
Unit has not preheated.
Steam/hot-water valve leaking.
Panarello blocked.
Unit too hot.
Rotary control in position
Water container has run dry.
Espresso powder too coarse.
Coffee powder not sufficiently
tampered.
Espresso powder too coarse.
Not enough espresso powder.
Espresso powder too file.
Too much espresso powder.
Filter holder not fitted properly.
Espresso powder residue on filter
holder rim.
Excessive amount of espresso powder. Use less espresso powder.
Solution
. Set the rotary control to
Fill water container.
Fit water container correctly.
Wait until the buttons stop flashing.
Switch rotary control repeatedly between
and .
Detach panarello and clean the air-intake
aperture on the side.
Let the unit cool down (see Making espresso,
Hint II)
. Set control to
Replenish water. Place a container under the
panarello and set rotary control to
water is emitted steadily.
Use finer coffee powder.
Use slightly more pressure.
Use finer coffee powder.
Use more coffee powder n. Reduce cup fill
quantity.
Use coarser powder.
Use less coffee powder. Increase cup fill quantity.
Re-fit holder correctly and lock properly.
Remove powder residue.
.
.
, until