Rear Panel; Ac-Connection; Legal Instructions - Omnitronic HDA Série Mode D'emploi

(6) HI CUT-CONTROL
Allows you to adjust the upper cutoff frequency. The low pass filter can be set from 60 to 250 Hz.
(7) BASS LEVEL-CONTROL
Used to adjust the bass level.
(8) GAIN-CONTROLS
Used to adjust the volume.

Rear panel

(1) JACK INPUT SOCKETS
Connect the input signals here using a balanced ¼" stereo jack.
(2) XLR INPUT SOCKETS
Connect the input signals here using a balanced XLR-plug.
(3) DISPLAY-LEVEL-SWTICH
For activating or deactivating the LEDs on the front panel.
(4) LOW CUT MODE-SWITCH
Activates the highpassfilter and allows you to cut down unwanted low frequencies.
In the BYPASS setting, the highpassfilter is not active.
In the 120 Hz-setting, you can attenuate all signals below 120 Hz.
In the 80 Hz-setting, you can attenuate all signal below 80 Hz.
(5) SPEAKER-OUTPUT SOCKETS
For connecting speakers.
(6) OUTPUT TERMINALS
For connecting speakers.
(7) FUSEHOLDER
Only replace the fuse when the device is disconnected from mains.
Only use fuses of the same rating and power.

(8) AC-CONNECTION

Used to plug the power cord in.

LEGAL INSTRUCTIONS

Operating an amplification system can produce extremely high noise levels that may cause a permanent
hearing loss. The legal instructions for using an amplification system vary from country to country. The user
must always inform himself on the legal instructions valid in his country and apply them to his situation.
Always monitor the sound pressure level when operating an amplification system in discotheques, concerts
etc. Never exceed the permissible noise level exposures as specified by your authorities. The monitoring of
the noise levels must be documented in an appropriate way.
In Germany, the follwing instructions are binding:
Strafgesetzbuch § 223 ff:
TA Lärm: http://www.umweltdaten.de/laermprobleme/talaerm.pdf
http://bundesrecht.juris.de/bundesrecht/stgb
21/34 10452350_V_1_0.DOC