Maintenance - Belling SE 90 DFT INOX Manuel D'utilisation

2. Open the saddle bracket (a)(with the aid
of a screwdriver) up to the end position.
a
3. Close the door until it almost reaches the
fully closed position and remove the door
by pulling it towards you.

5.2. Maintenance

WARNING: The maintenance of this
appliance should be carried out by an
authorised service person or qualified
technician.
Change of Oven Lamp
WARNING: Switch off the appliance
and allow it to cool down before
cleaning your appliance.
• Remove the glass lense and then
remove the bulb.
• Insert the new bulb (resistant to 300°C)
to replace the bulb that you removed
(230 V, 15-25 Watt, Type E14).
• Replace the glass lens, then your oven
is ready for use.
The lamp design is designed specifically
for use in household cooking
appliances. It is not suitable for
household room illumination.
5.3. Maintenance
WARNING: The maintenance of this
appliance should be carried out by an
authorised service person or qualified
technician.
Other Controls
• Periodically check the gas connection
pipe. If a defect is found, inform the
technical service to have it changed.
• We recommend the gas connection
components are changed annually If
a defect is found while operating the
control knobs of appliance, contact the
authorised service.
EN - 23