Listening To Dab Radio - Yamaha AVENTAGE CX-A5200 Guide De Démarrage

MAIN 2 3 4 MAIN 2 3 4
SLEEP SLEEP SLEEP SLEEP ZONE ZONE
PARTY PARTY PARTY P P P P A A A A P P P P P P R R R R T T T T Y Y Y Y T T T T T T T T T P P U PUR R E D PURE DIRECT PURE DIRECT PURE DIRECT E DIR IR C EC ECT T HDMI OUT HDMI OUT HDMI OUT HD HDM M I I O O U U T T
SCENE SCENE SCENE SCENE
1 1 1 1 2 2 2 2 3 3 3 3 4 4 4 4
5 5 5 5 6 6 6 6 7 7 7 7 8 8 8 8
INPUT INPUT INPUT INPUT
TUNER
TUNER TUNER TUNER NET NET NET NET USB USB USB USB BLUETOOTH BLUETOOTH BLUETOOTH BLUETOOTH
PRESET PRESET PRESET PRESET
RED RED R R R R R E E E E E D D D D D RED G G G R R E E E E N N GREEN GREEN GREEN YELLOW YELLOW Y Y Y E E L L L L O O O O W W W W W W W W W YELLOW BLUE B B B L L L U U U E E E BLUE BLUE
ENTER
TOP TOP TOP TOP POP-UP POP-UP POP-UP POP-UP
HOME HOME HOME HOME
MENU MENU MENU MENU / / / /MENU /MENU /MENU /MENU
AI AI
SUR. DECODE SUR. DECODE SUR. DECODE SUR. DECODE S SUR. DECODE SUR. DECODE SUR DECODE CO
PROGRAM PROGRAM P P P P P OG PROGRAM ROG ROGRA OG OG RAM M V V V O O O O O O O L L U U U U U M M E E VOLUME VOLUME VOLUME
ENHANCER ENHANCER
STRAIGHT STRAIGHT STRAIGHT STRAIGHT
MEMORY MEMORY MEMORY MEMORY MEMORY MEMORY MEMORY MEMORY MEMORY MEMORY MEMORY MEMORY MEMORY O
BAND
TUNING TUNING TUNING TUNING BAND BAND BAND BAND TUNING TUNING TUNING TUNING
TUNING
22
En
Setting the frequency steps
(Asia, Taiwan, Brazil, General, and Central and
South America models only)
At the factory, the frequency step setting is set to 50 kHz
for FM and 9 kHz for AM.
Depending on your country or region, set the frequency
steps to 100 kHz for FM and 10 kHz for AM.
1 Set the unit to standby mode.
2 Hold down STRAIGHT on the front panel and press
MAIN ZONE z.
3 Press PROGRAM on the front panel repeatedly to
select "TUNER FRQ STEP".
TUNER FRQ STEP
FM50/AM9
4 Press STRAIGHT on the front panel to select
"FM100/AM10".
5 Press MAIN ZONE z to set the unit to standby mode
and turn it on again.

Listening to DAB radio

(Australia, U.K., Europe, Russia, and Middle East
models)
1
Press TUNER to select "TUNER" as
the input source.
2
Press BAND to select the DAB
band.
The following message appears on the front panel if
you have not performed an initial scan yet.
Init Scan
Press [ENTER]
3
Press ENTER to start an initial scan.
Init Scan
>>>------- 30%
When the initial scan finishes, the unit automatically
tunes into the first DAB radio station as stored in
station order.
DAB BBC Radio 4
4
Press TUNING repeatedly to select
a DAB radio station.
VOL.
VOL.
VOL.
FPL L C R FPR
SL SW1 SR
SBL SBR